Need a manual and cabling diagram for IPG Laser. PYL-60 with driver.

[GregR]

Need some help on an item purchased used. This is an IPG fiber laser model PYL-60 and a laser driver. This laser may be a 60 watt CW laser. I also have a used diode PLD-6-4.

It would be great to power on and test. No cables came with this laser and no manual. Any help or suggestions are greatly appreciated.

[Power]

Did you try to contact IPG? They would be the place where you could get your questions answered.

[ramjoce]

Did you have any luck? i have this PYL-10M and a similar driver, i believe the cable is just strait... pin 1 to pin 1 and so on, i could get some info on the led display like hours, but it still can't fire the beam, i'm missing something, could find manual online, ANYONE? please?
Thank you

[javanam]

i have also a pyl-50m without puwer supply and searching manual/pinout

[javanam]

Some photos from inside..
It has 28 diodes
What is +LD1(pins 10-11) +LD2 (pins 12-13) ?
1-2-3-4 pins is GND

7-9 pins seem some control signals..

outside label write 31VDC

[Ijaz]

Some photos from inside..
It has 28 diodes
What is +LD1(pins 10-11) +LD2 (pins 12-13) ?
1-2-3-4 pins is GND

7-9 pins seem some control signals..

outside label write 31VDC

Were you able to make it work ? Any progress ?

[VDX]

... ich this is a CW- or QCW-type, then the diodes are wired in two serial banks -- I have a 130Watt CW with broken elektronics and simply connected one of the banks and could "revoke" the laser with same quality by giving power to it - didn't seem different compared to another one, I have in working condition ...

Viktor