i have ild sos and i use it to optimize some frames where connected points or blanking points are too far apart.
but ild sos only seems to allow to add inbetween points if you enable the 'Optimize' options. but what that does is allow you to set the speed of your scanners and it adds as much inbetween points as it can until it is 30K, it doesnt allow you to set min/max connected point distance.
is this considered a "bad" frame and animation now? i dont have the experience yet and not thinking about it, but if i were to sell an animation processed like that, would that be a bad quality job and animation because the frames have 30k frames even when not needed? and if i bought animation from someone and it had such frames, should i complain?
Or is it that if the animation is meant to run at 30k, this is normal?