I think it is a MediaLas!
Yes, it's from Medialas. For more pictures look at: http://www.laserfreak.net/forum/viewtopic.php?t=38965
the diode3 mounts look like Arctos as well..
edit...
perhaps the dont
The mounts def are
Last edited by dave; 04-03-2007 at 23:10.
KVANT Australian projector sales
https://www.facebook.com/kvantaus/
Lasershowparts- Laser Parts at great prices
https://www.facebook.com/lasershowparts/
Cool lookin' little mirror mounts.
hi guys (and gals?)
My red lasever unit is occasionally flickering on and off ? anyone got any ideas why that might be. All 3 lasever units are mounted on the same 10mm baseplate and the green and blue are fine, so i'm assuming its not an earthing issue ? each uses its own 1 amp psu. Could it be a dodgy psu ?
i haven't yet tried to see if it flickers when connecting the modulation lead to the 5v supply, next thing to do.....I'll try switching the psu around also....
dave321
When it flickers, check to see if the red LED on the driver is turning on at all. I had this issue intermittenly with all three when they were in contact with each other. Which is why I replaced the three individual supplies with a single supply.
Hmm, if you are running these with a 5V 1A supply then you are amazing! Under normal operation my green laser pulls 4.5amps. I have not checked the other two lasers, I suspect the red is a bit less than the other two, but you should plan on at least a 5 amp draw per laser. Which is why I chose a 5V 20A supply.
David
I built my V4. RGB laser projector 800mw
I use
2*200mw 658nm red laser
400mw 532nm green
300mw 473nm blue
I need 40% more red to get white
check pict
Looks nice! Good job.
"Gravity its not just a good idea its the law"
Look like a nice layout. A little chaotic, but whatever gets them alighned huh? What kind of blue is that?