Hi all,
Just received some Flexmod P3 from Illumination Supply and want to install 2 resistances for beam suppression feature following the manual:
http://innolasers.com/laser/FlexModP...dP3_Manual.pdf
But reading manual it says "If ordered, your driver is capable of suppressing the standby glow produced by the laser when modulation is off"
"IF ORDERED" seems there are 2 different flexmod drivers? One capable of beam suppression (with the resistances mod) and the other one not?
So, the question is, I have a "current" FMP 3.3 flexmod driver, I've not ordered beam suppression (thats my fault
Could I be able to operate with beam suppression if I solder the resistances on it? Or it should be another flexmod? (with different firmware..I don't know)
Many thanks!!
Jordi