Hi Guys.
Have to come in to the discussion.. and sorry for my bad English (i'm from Sweden
Have the same problem as you have, but i could't remember having it before when i didn't use pangolin.
Only have a 2 watt Excel green laser with Ct6800 scanners and some pico driver from HB-Laser.
When i got the FB3 i was really happy since i got more power out of it when i was doing beams, comparing to the old one.
But now i also updated to Beyond, and was playing around with that and did try to re tune my scanners but couldn't get the lines
before/ or after to disappear!!.
Did get some help finding this forum and checked your post, and had to try to find my old interface and a software for it to try it out.
And in that software (LDS) LaserDesignStudio (not pangolins) i can take away the lines and get nice dots!!
So if its a scanner problem, why can i make it look nice in that software then??
Have some new CT6215 lying with CT own amp, so going to se if i can make a small bench and try them out to..
Also did buy some cheap rgb laser for a nightclub with DMX, ILDA and Audio control.. so it has a lot of internal programs, and if it would be a scanner problem
why does that one produce nice dots when running internal programs and when run with pangolin it gets the lines again..
For me it feels like the blanking is made the same way if you run it with an internal program or external?!?!?!
//Robert