Lumonics HPM VM2 galvo

[peterklos]

Hope you can help , I am reassembling my Lumonics Galvo and have misplaced the cable that goes from the input board to the X/Y Galvo drivers .

does any one have a circuit diagram of the HPM Vm2 Galvo or know the pin connection details , so I can make a cable

Thanks in Anticipation

Peter

[mixedgas]

same question, hopefully there who can help..

Cambridge Technologies inherited GSI Lumonics. That is where you will find your support.
Call them, usually they are helpful.

Steve

[peterklos]

Thanks Steve
I contacted them prior to posting on the forum
this was the reply

Hi there,
Unfortunately,
This scanner has been obsolete for quite some time.
Thanks VF


any suggestions on who I should contact < I am in Australia and cant call

peter

Cambridge Technologies inherited GSI Lumonics. That is where you will find your support.
Call them, usually they are helpful.

Steve

[mixedgas]

GO here:

http://www.camtech.com/index.php?opt...d=87&Itemid=75

See if the connectors line up with any of the VM series there, or in the product manual archive.

Steve