DT 40 Pro set or......

[werner1619]

Laser software: Phoenix pro
Scanners: DT40 pro

Hope it sheds more light on the mistery...

[buffo]

Ok, so Phoenix pro is similar to Laser Design Studio. Unfortunately, I don't know how to change the scan speed on that software. But assuming that your controller (the hardware that connects your computer to your projector) has a good, stable frame buffer clock you should just be able to set the scan speed at 30Kpps and be assured that it's right.

Hopefully someone will chime in here with details on how to check / adjust the scan speed in Phoenix Pro...

Adam

[dave]

Hi buffs,

I feel realy stupid asking the following qeustion after reading all the posts in this thread, but can some one explain to me how to propperly tune scanners to ILDA 30k?

I think I have PR scanners, got them from Lumina, after reading about ILDA 30k test patern the first time I tried to reset the scanners in hope of better performance and since then the scanners have never been the same again!!

Another stupid qeustion, Lets assume your scanners are set/ tunned to ILDA 30k, how do you ensure that your software controlling the scanners are doing the right thing/ sending the right signals to match the tuned state of the scanners??

Hoping to get this ILDA test patern and setting under the knee once and for all....

(thanks for not laughfing)

The PR scanners are well tuned in the factory. (Tuned to 30k)

Perhaps if you want them retuned you can return them for a retuning.

[allthatwhichis]

I got a dumb question... What are the PR Scanners?

[dave]

the scanners we sell, the scanpro's