Please help me with this logo!

[lpathiks]

My hearty greetings to all

Im new to the field of laser show,I reques you all to help me with a logo I badly needed for my
debut show .[ATTACH=CONFIG]45449
followed by the text
"SHREE VENKATESHWARA DRAMA SCENARY"
i HAVE A 15KPPS RGB LASER 300MW

my many thanks to you all awesome people in advance

[james]

There is way to much detail in that image.

[absolom7691]

If you took 2/3 of the sun rays out, removed the concentric circles that are in the center of the sun, took the all dots out of the entire image and took out some of the detail from the smaller circles below the tower, you might have a chance with some 30K galvos. Even with all that detail removed, 15K galvos are going to chug and give you a ton of flicker.

It's been butchered but this is probably about the most detail you can expect a projector to perform:


Even then, 15K galvos are going to flicker a lot

[mccarrot]

or buy 3 more projectors and divide this picture over the porjectors

[masterpj]

You could scan this with 2 projectors running at 30kpps or 1 projector with scanners that are ment to run at 60kpps~50kpps and heavy optimizing.
That is if you have CTHP laser scanners tuned at 60kpps or the Eyemagic scanners or the ??506 scanners by pangolin tuned at 40~50kpps??

Anyhow with 15kpps even I can't help you.

[White-Light]

Plus with a single projector, the text would have to be displayed separately - maybe the logo for X seconds, then scrolling text and back to the logo etc in a loop.

Absolutely no chance of displaying all that text on its own in one go, never mind the logo.