DT40Pro's and Scanfail card

[Jem]

Hi

Does anyone know if there is a way of wiring the DT40Pro's up to a scan fail card. Is there a feedback output on the DT40's?

I've emailed Jian and he has suggested 'trying' J5 (marked safety). This doesn't sound too certain and I don't want to risk any damage. The scan fail card would be one of the LaserVisuals(UK) ones.

Andy, one of the guys also on the LaserVisuals course, who is also looking at the scan fail card thinks there should be +/- from each galvo return so it can compare with the input, then if there is any difference it will see it as a fault,

Any suggestions?

Jem

[dave]

Theres some interesting info in this thread:

http://www.photonlexicon.com/forums/...ead.php?t=1368

As a matter of fact, im just in the process of doing code for a basic scan fail board.... All in assembler

[Starburst]

Hi!

I`ve connected the DT40Pro driver to gento`s safety and it works perfect. Use jumper 5!

Best regards
Karl

[jian725]

Hi!

I`ve connected the DT40Pro driver to gento`s safety and it works perfect. Use jumper 5!

Best regards
Karl

All right,but the safety board not a standard desing.can't sure DT40pro connect other safety works perfect.
Jian