Chinese laser driver wiring?

[Tomtortoise]

So after 7 weeks of waiting, my laser and driver finally arrived... anywho I was able to figure out that the two bottom left outputs are laser outputs but I cant figure out which is VIN, the TTL In, and fan out (if it has one). It looks to be a common driver shipped from china so if anyone has used one and knows any information on this, please post it.

[drm916]

Turn over the driver. The back of the driver will be labeled. On the back of the black plastic. Everyone I have ever seen is labeled back there.

[drm916]

This is a completely different auction and driver from ebay. But this illustrates what I mean

http://i.ebayimg.com/00/s/MTA3MVgxNj...StpCV/$_57.JPG


If its not labeled then you need to contact the seller.

[dkumpula]

Turn over the driver. The back of the driver will be labeled. On the back of the black plastic. Everyone I have ever seen is labeled back there.

Yup! On the off chance that it isn't labeled, it is frequently listed on the board itself partially under the male plugs on the board. You can usually slide up the plastic housing without affecting the soldered male leads.