FlexMod p3 interlock

[fcanducci]

Good Morning
I purchased the card FlexMod p3 (interlock monitor output).
Now I was trying to do the setup, but I always have the red LED on and no output, can not figure out how to maintain closed interlock.
Can anyone help me

thanks 1000

Google translate

[Datsurb]

The manual can be downloaded here:
https://innolasers.com/shop/index.ph...roller=product

It says: Iterlock must be connected to V+.

This thread gives you a good idea of what and how.
http://laserpointerforums.com/f51/ho...ser-56572.html

[dummie]

Everything's already properly set up. The interlock light is pulsing on/off for a few times before it stays on.

[dummie]

Everything's already properly set up, as can seen from the pictures. The interlock light is pulsing on/off for a few times before it stays on.

[dummie]

Everything's already properly set up, as can seen from the pictures. The interlock light is pulsing on/off for a few times before it stays on.
Also, my setup is different because of the modulation from arduino.

[dummie]

I'm unsure what happened on this thread, could a kind mod remove my triple post?