Senior Member
CNI OEM-H-532-1W running very hot
I have put together with a friend 2 identical projectors with the CNI OEM-H-532-1W.
One of them starts nice, good white balance but after 19 minutes it heats up and drops from 1.4W to about 100mW.
I would like to know if any of you have info on how to verify the drivers configuration for the peltier driver.
Thanks in advance, here is a pic of the driver as a reference:
Michel
--------------------------------------------------------------------------------------------------------------------------------------------
Michel Rietveld @ Utrecht The Netherlands
FB3, BEYOND Ultimate, 3xFB4, apc 40
1x5W RGB 637nm 1.3W, Edison Blue 2.5W 445nm and CNI 2.5W 532nm Greenie with Pico driver with DT40Kpro scanner set
2x3W RGB DT30 scanner set
Senior Member
more pictures of the laser and setup, got feedback from cni that they are on a business trip and suspect the tec to be defective, anyone with knowledge on how to measure and test this?
pics below.
--------------------------------------------------------------------------------------------------------------------------------------------
Michel Rietveld @ Utrecht The Netherlands
FB3, BEYOND Ultimate, 3xFB4, apc 40
1x5W RGB 637nm 1.3W, Edison Blue 2.5W 445nm and CNI 2.5W 532nm Greenie with Pico driver with DT40Kpro scanner set
2x3W RGB DT30 scanner set
Senior Member
This is pretty common with the H series. I have had a few go bad. Its the driver and tec. they are not very stable and seem to break a lot. I ended up just replacing mine. I know that's not what you wanna hear
Posting Permissions
Reply With Quote