Senior Member
Hiatus under the LBO crystal
Hi,
The green laser module is work good, but I little bit worried the LBO crystal of life time.
LBO crystal does not fill on the plate well. This is hiatus and other side is skew.
I attached the photos.
The LBO house in the middle of a small aluminum plate is lifted.
Questions: Proper cooling of the crystal now? Can I fill in the gaps? What about the skew position?
What is the LBO optimal temperature?
Thank you the tips,
Last edited by whiteg; 07-14-2015 at 02:16.
Photos: https://www.photonlexicon.com/forums...hp?albumid=422
My edited show videos in youtube: https://www.youtube.com/playlist?lis...3JHLjLat29Z7Nk
Member
What is the power of the laser module?
Not every line is shorter than the curve.
Senior Member
The power is 500mw.
Photos: https://www.photonlexicon.com/forums...hp?albumid=422
My edited show videos in youtube: https://www.youtube.com/playlist?lis...3JHLjLat29Z7Nk
Member
500 mw - small power.
But, if you are afraid of overheating сrystal, filling the space under the crystal house with thermally conductive adhesive.
Not every line is shorter than the curve.
Posting Permissions
Reply With Quote