Page 2 of 2 FirstFirst 12
Results 11 to 15 of 15

Thread: driver identification/adjustment help

  1. #11
    Join Date
    Aug 2011
    Location
    Alabama
    Posts
    271

    Default

    Ordered a couple replacement pots today. I'll see if that fixes the problem.

  2. #12
    Join Date
    Aug 2011
    Location
    Alabama
    Posts
    271

    Default

    The new pots did not fix anything. FWIW, I thought I had the 826 sleds. They were 815s. That is what I used in one of my handhelds though. It is putting out at least 225. At this point, all I want to do it replace the driver itself.

  3. #13
    Join Date
    Aug 2011
    Location
    Alabama
    Posts
    271

    Default

    Okay, I got another driver. There may be a more in depth problem. I run the palette setup in LD2000 and set it to the channel my 660 is on. I can't get the driver to put out more than 350mA.

    I'm not sure how the ILDA signal controls the brightness. Does it have something to do with how high the voltage is that the DAC sends? Is there a way to trick the driver into thinking it's receiving a "full on" signal?

    ETA some more stuff.

    Let's say I have two 1.9 ohm resisters in parallel. The actual resistance would be .95. The multimeter should read .95, right? I get ~2.4 ohms across one pair and about 1.8 across the other. See the diagram below to understand. The voltage is ~3.99 with the laser on. The driver is supposed to put out up to 2A though.LD.jpg
    Last edited by DrEvil; 08-28-2015 at 04:59.

  4. #14
    Join Date
    Jan 2006
    Location
    Charleston, SC
    Posts
    2,147,489,632

    Default

    Looks like your resistors are nowhere near spec. You should see something close to 1 ohm across each pair.

    What is the wattage rating of each resistor? They should be rated for at least 1/2 watt, and 1 watt would really be best. (Assuming each diode pulls 500 ma, then each resistor is seeing .25 amps, which at 1.9 ohms would yield .475 watts. That's dangerously close to 1/2 a watt.)

    Adam

    PS: When you measure voltage on the driver you need to use an oscilloscope. Contrary to popular belief, the color signal is not pure DC. There are built-in breaks in the color signal at the frame boundaries. So if you use a standard multimeter you will be measuring a lower-than-normal voltage, because it will average those drop outs. Use a 'scope and you will see a square wave with a long duty cycle. Your color signal level is the peak of that square wave.

  5. #15
    Join Date
    Aug 2011
    Location
    Alabama
    Posts
    271

    Default

    I got it figured out. Now my problem is getting things aligned. The lenses were epoxied into place. I think the builder did that first. Then adjust the mirror and cube until a single beam was produced.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •