You can show my 4 stages megawatt TEA nitrogen laser Under : http://www.swissrocketman.fr/051-las...s,fr,3,230.cfm
femtoman
You can show my 4 stages megawatt TEA nitrogen laser Under : http://www.swissrocketman.fr/051-las...s,fr,3,230.cfm
femtoman
What mechanism creates the firing timing or delay between stages? Velocity in the PCB should be ~0.85 C, Yes?
Steve
Qui habet Christos, habet Vitam!
I should have rented the space under my name for advertising.
When I still could have...
the preionisation and the discharge électrodes gap !
Ah that would work, no room for traveling wave in the PCB...
Very innovative... 0.5 mJ is respectable..
Steve
Qui habet Christos, habet Vitam!
I should have rented the space under my name for advertising.
When I still could have...
This is not new ! I have patented this system since 1980 and sale more than 60 lasers for drift chamber calibration (CERN, FERMILAB, ....) with a MOPALITE laser of 600 kW peak power using one oscillator and one amplifier of 150mm long http://www.swissrocketman.fr/lasers-...te,fr,3,17.cfm
Beautiful!
-George
Have you tried it with Neon for the green and orange pulsed lines?
Steve
Qui habet Christos, habet Vitam!
I should have rented the space under my name for advertising.
When I still could have...
You cannot modify a TEA N2 laser in a TEA Neon laser !
In 1966 AVCO EVERETT RESEARCH LAB commercialize the model C400 .This laser has a cavity length of 1000 mm and electrodes separation of 50mm.
The neon pressure Inside the cavity was 30 torr and the discharge voltage 45kV and 500A to 1000A
My TEA nitrogen laser has 2mm électrodes separation and 450 mm length .
I cannot work at reduced pressure with this cavity !
The problem at atmospheric pressure is to obtain in neon an homogen discharge
femtoman
femtoman;319939]
You cannot modify a TEA N2 laser in a TEA Neon laser !
TE Neon laser work between 10 to 80 torr pressure
In 1966 AVCO EVERETT RESEARCH LAB commercialize the model C400 .This laser has a cavity length of 1000 mm and electrodes separation of 50mm.
The neon pressure Inside the cavity was 30 torr and the discharge voltage 45kV and 500A to 1000A
My TEA nitrogen laser has 2mm électrodes separation and 450 mm length .
I cannot work at reduced pressure with this cavity !
The problem at atmospheric pressure is to obtain in neon an homogen discharge
femtoman[/QUOTE]
I enjoy looking at these old documents. Do you note that the combined shipping weight is 1000 lb for a laser that generates an average of 3mw of output!