Colour changes when fading in on quickshow timeline

[djpaul]

Hi

When i fade an image in on the Timeline it comes out the wrong colours on my laser as it fades in
When its at full brightness it changes to the correct colours

Any ideas why?
Is this normal?

Paul

[JohnYayas]

Could be something to do with the linearity of you laser modulation. I believe Quickshow allows you to set the linearity of each color in the settings. Check that out. Or maybe they have been messed with and are out of whack and need to be fixed.

[djpaul]

Hi John

I am just about to give that a try
Its a brand new projector from Kvant
I will let you know if changing the colour settings helps

Paul

[norty303]

Its a common problem, particularly where a DPSS head is in the mix.
In Beyond I know you can set custom curves and start/end points for every colour, but I think QS may just have a choice of linear or log (its been a long time since I fired up QS!)

[djpaul]

Okay
Its a bit better now with The Quickshow Linear colour Min Voltage set at

Red 7
Green 8
Blue 7

[djpaul]

I got it looking a bit better ... But not great
I have decided against using fades now as its not perfect and looks better without them

Thanks anyway for the advise guys

[norty303]

Can you select the type of curve in QS? If so, try the other one if you haven't already.

[djpaul]

No i dont think you can
Unless someone here can point that out to me

[norty303]

http://pangolin.com/QS/extras/QuickShowQSManual.pdf

Page 18 - linear or log response curves

[djpaul]

Hi

I have it set to with log response curves