Maxyzmodules 225mW RED module, singles and duals
Decided a new thread was in order, Last one got trashed
For Sale:
As seen on ebay and on this site !!!
Maxyzmodules RED 660nm 225mW laser module
As of : August 3 2007 (updated EUR)
for Photolexicon members ..
269.95USD or 197.80EUR each --
Shipping is 15USD for USA and Canada
25USd or 18.39EUR for International orders
284.95USD Total for USA or 294.95USD (216.88EUR) total for International
That's 539.90USD for a Pair ...(396.99EUR)
Same price shipping...Limited time offer ...
They come Analog modulation...Altho , You can use the analog units in TTL configuration.
These will include the new driver board with full blanking to well over 30khz. (useful to at least 100khz)
Also included FREE is a 9volt wallwart power supply (while supply lasts)
they operate from 120/220ac 50/60hz
If you need a mounting plate, We offer them at 25USD 18.39EUR each
These are for mounting of a single unit.
If you need a dual mounting plate for combining a pair 45USD 33.09EUR each.
..set-up and predrilled for mounting of a MM-1 or equivalent mirror mount and a MM-1 /BS or equivalent like the one pictured in below.
still have a few for you guys that want to roll your own:
Laser_line PBS cube 165.00USD or 121.33EUR
Laser-Line PBS cube mounted to MM1 or KMS is 235.00USD or 172.80EUR
Laser-Line mirror mounted to MM1 or KMS is 75.00USD or 55.15EUR
Plus shipping.
Grab a couple and find a Beamsplitter or Pol Cube and combine them
for more power... I get over 430mW out of my setup real fast.
If you buy 2 , I will set one of them up Opposite polarity for easier combining!!!
If you buy the whole set-up its 805USD plus 20USD in USA/Canada , 825USD total
or 830USD 591.92EUR plus 30USD 22.06EUR international shipping , 610.30EUR total
Each unit is handcrafted. therefore.. great care is put in each unit before they leave..
The power is doublechecked with a Melles Griot and Scientech broadband power meters.
All parts are NEW .. except the heat sink which is black anodised
However , We have just started to paint them with a special FLAT BLACK paint.
The beam diameter is less than 2.5mm (always) mostly around 2.2mm
and divergence less than 1.0mR. Typically .8mR.
Only a few complete set-ups left till we get more mounts..so hurry !!!
Oh and dont forget, if paying by PAYPAL please add the 4percent they charge for their cut
Thats about 33.00USD or 24.27EUR for the duals.
Some of these pictures are old.. I will get some new ones up soon.
The combined plate has been redesigned slightly so no holes are covered and are spaced correctly.
Still using 3/8" holes spaced 5" each way on the 6" by 6" plates.
The diodes are NOT the small 100mW DVD diodes...!!!
And we thank everyone who has bought these...enjoy
Please PM me for more info
Thanks
Last edited by marconi; 08-03-2007 at 14:56.
"My signature has been taken, so Insert another here"
http://repairfaq.ece.drexel.edu/sam/laserfaq.htm
*^_^* aka PhiloUHF