Results 1 to 2 of 2

Thread: DT 40 tuning

  1. #1
    Join Date
    Jul 2005
    Location
    Flying over a town near you
    Posts
    1,404

    Default DT 40 tuning

    In light of all the articles here on these scanners , I am not impressed. I have taken note that they NEED to be tuned. I have searched and read of these being tuned for single ended ops. I am running them in symmetrical wiring setup and ISC is turned down to about 2 turns off bottom of tuning for that pot. I have full control of the signal as far as size, geometric correction, and image inversion through the software. It does function better than the 9024's but they are not tuned for the crispness that I know they can do. Scan angle is 12Deg. Is there a way I can tune them without a scope? Or at least a set of simple guide lines that I could get closer with them? I guess the next thing for me to get is a scope and begin a new learning curve. I am in this too deep to back up now. Any help will be gratefully accepted. And I have not moved any other pots......for now.
    You are the only one that can make your dreams come true....and the only one that can stop them...A.M. Dietrich

  2. #2
    Join Date
    Nov 2005
    Location
    Melbourne, Australia
    Posts
    3,702

    Default

    Here is a good page on tuning -

    http://www.laserfx.com/Backstage.Las...Scanning3.html

    If you are getting into lasers past plug and play, a scope is essential.
    KVANT Australian projector sales
    https://www.facebook.com/kvantaus/

    Lasershowparts- Laser Parts at great prices
    https://www.facebook.com/lasershowparts/

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •