Page 5 of 5 FirstFirst 12345
Results 41 to 45 of 45

Thread: Ether Dream 2

  1. #41
    Join Date
    Aug 2018
    Posts
    3

    Default

    Did you already find a solution for it?

  2. #42
    Join Date
    Dec 2017
    Posts
    8

    Default ED2

    I contacted Jacob, and he answered me. I quote:

    I've attached a debug firmware. Load this onto the ED2 by connecting it over USB and replacing the existing "ed2.fw", then try again.

    There will be new LED blinks at two points during startup. A normal LED sequence with autoplay will be:
    - Red ascending sequence
    - Bottom LED blinks green once
    - Blue ascending sequence
    - Green ascending sequence
    - Bottom LED blinks blue a few times
    - Autoplay starts (middle LED will light up).

    If the initial bottom LED green blink doesn't happen and you get three red blinks instead, it's not finding autoplay.txt - this could indicate a problem with the filesystem or partition format on the SD card. If there are red blinks at the end instead of blue, this means there's an error with the contents of autoplay.txt. This should help us narrow down the problem

  3. #43
    Join Date
    Aug 2018
    Posts
    3

    Default

    Thanks for the reply! Can you also send me the firmware please?

  4. #44
    Join Date
    Dec 2017
    Posts
    8

  5. #45
    Join Date
    May 2016
    Posts
    3

    Default

    Hello everyone, and sorry for bringing this up again... but I'm experiencing exactly the same problem(s) @AlexRu described, and was wondering if a solution has ever been found?

    Cheers

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •