Results 1 to 4 of 4

Thread: Which type of connectors

  1. #1
    Join Date
    Sep 2016
    Location
    Belgium - Europe
    Posts
    13

    Default Which type of connectors

    Hello,
    I doesn't seem to find much information about most common used types of connectors on this forums.
    On my projector (PT-iTrust board, simpledrive 2.5A) there are all kinds of connectors used. For connecting the simpledrives i removed the plastic connector housing and soldered my wires direct on the boards. But on the showcard (next time i will use a breakout board) i didn't know which connectors there are used. Does anyone know this? When you guys for example make connections outside circuit boards, which connectors do you use?

  2. #2
    Join Date
    Sep 2006
    Location
    Netherlands
    Posts
    1,425

    Default

    a photo would help.

  3. #3
    Join Date
    Dec 2009
    Location
    Laurel, MD
    Posts
    366

    Default

    Most common connectors I've seen used in projectors:

    JST-XH series
    http://www.jst-mfg.com/product/detail_e.php?series=277

    TE MTA 100 and 156
    http://www.te.com/usa-en/products/co...?tab=pgp-story

    TE Micromatch
    http://www.te.com/usa-en/products/co...?tab=pgp-story

    Molex Minifit Jr. (less frequent but good for power connections)
    http://www.molex.com/molex/products/...e=Introduction

    and of course the classic IDC ribbon cable connectors

  4. #4
    Join Date
    Sep 2016
    Location
    Belgium - Europe
    Posts
    13

    Default

    Thank you for the info.
    I find out that in the PT-itrust - PT20K they use Molex2510 connectors.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •