Which type of connectors

[KrisVermeulen]

Hello,
I doesn't seem to find much information about most common used types of connectors on this forums.
On my projector (PT-iTrust board, simpledrive 2.5A) there are all kinds of connectors used. For connecting the simpledrives i removed the plastic connector housing and soldered my wires direct on the boards. But on the showcard (next time i will use a breakout board) i didn't know which connectors there are used. Does anyone know this? When you guys for example make connections outside circuit boards, which connectors do you use?

[-bart-]

a photo would help.

[araugh]

Most common connectors I've seen used in projectors:

JST-XH series
http://www.jst-mfg.com/product/detail_e.php?series=277

TE MTA 100 and 156
http://www.te.com/usa-en/products/co...?tab=pgp-story

TE Micromatch
http://www.te.com/usa-en/products/co...?tab=pgp-story

Molex Minifit Jr. (less frequent but good for power connections)
http://www.molex.com/molex/products/...e=Introduction

and of course the classic IDC ribbon cable connectors

[KrisVermeulen]

Thank you for the info.
I find out that in the PT-itrust - PT20K they use Molex2510 connectors.