Etherdream 2 DMX out

[mmuhler]

Hey Lasermaster

I will let Jacob confirm but this is DMX out and you would solder up a 3pin XLR connector as follows to match the silk screen labels on the board

[lasermaster1977]

Hey Lasermaster

I will let Jacob confirm but this is DMX out and you would solder up a 3pin XLR connector as follows to match the silk screen labels on the board

I'm very new to the ED2, so I assumed this was an input to control aspects of display controller's ability to use an SD memory card for image/frames.

Ol' dog still learning new tricks :-)

[mmuhler]

I'm very new to the ED2, so I assumed this was an input to control aspects of display controller's ability to use an SD memory card for image/frames.

Ol' dog still learning new tricks :-)

Hi Lasermaster 1977
I have a bit of DMX background so I can help if you need it and want to use DMX to control the projector.

I just hooked up my new Etherdream to the latest version of LSX and LSX comes up like it should registered and all. The Sitter diagnostic tool that I downloaded from the ED2 site finds it on the network status is idle. I try to output to my laser projector using the demo file in LSX I see it playing in the preview window and no go from the projector. I see the etherdream.dll file in the LSX folder, Any suggestions would be greatly appreciated.

M

[swamidog]

jump back into IRC and i'll try to give you a hand.

Hi Lasermaster 1977
I have a bit of DMX background so I can help if you need it and want to use DMX to control the projector.

I just hooked up my new Etherdream to the latest version of LSX and LSX comes up like it should registered and all. The Sitter diagnostic tool that I downloaded from the ED2 site finds it on the network status is idle. I try to output to my laser projector using the demo file in LSX I see it playing in the preview window and no go from the projector. I see the etherdream.dll file in the LSX folder, Any suggestions would be greatly appreciated.

M

[mmuhler]

jump back into IRC and i'll try to give you a hand.

Hi Chris
Sorry I get up at 5am and was falling asleep at the computer I did not see this until this morning I will PM you.

Best
M

[lasermaster1977]

Hi Lasermaster 1977
I have a bit of DMX background so I can help if you need it and want to use DMX to control the projector.

I just hooked up my new Etherdream to the latest version of LSX and LSX comes up like it should registered and all. The Sitter diagnostic tool that I downloaded from the ED2 site finds it on the network status is idle. I try to output to my laser projector using the demo file in LSX I see it playing in the preview window and no go from the projector. I see the etherdream.dll file in the LSX folder, Any suggestions would be greatly appreciated.

M

Thanks, I'd love to get some insight into DMX. I've only played with it a tiny bit using ENTTecs OpenDMX USB controller with Vixen software for Xmas lighting. I see from reading the Ether Dream 1 documents that Ether Dream 1 & 2 listens on UDP 7654 for OSC commands. Need to bone up on OSC commands, but how neat is that! Now I understand why on ED2 there is only a DMX Out.

Did you "associate" the ED2 to a timeline in LSX?