So, quick introduction, I have been out of the laser bit for 10 years or so. I used to run completely live and saved imagery shows (I controlled color/modulation, effects, etc). I ran across a friend with a sweet laser pointer, and it started my interest again. I am part way through building my own rgb projector. 2.5W or so mostly from memory. I have gotten everything down so far, save one item, and that's why after about 4 months of looking around on here I finally signed up.
Hopefully someone can point me In the correct direction, yes I have searched.... for hours... And cannot find my answer. So here goes:
I am modifying a blackface adat for ilda output using the pango guide and this thread https://www.photonlexicon.com/forums...Expanded/page2
But I cannot figure out how to properly limit the output of the x-y channels to +/- 5v. I am going to be using pt-30k scanners from spacelas and their limited documentation says +/- 5v input. Any help would be greatly appreciated.
I have a donor elco cable so I can use the connector and the 1/4 connectors as needed to make whatever whatever outputs I need for the projector.