Ok, so I have worked out most of the major issues with the scanners now, so I thought I would upload some pictures, see what you all think.
Breadboard was an epic ebay find, 75$!!, for inch thick 30" x 10" board. all optics are mounted on this board. Upper level holds the power supplies and the drivers. Using a 12v Meanwell PS for fans and diode drivers, Lovell Diode drivers, PT-30K scanners, assorted ebay find kinematic mounts, Newport and Thor labs, flex mounts from optlasers, diodes from DTR.
Rectangular dichroics are from OPT, round dichroics are Stanwax. aluminum bits I machined, aside from the 20mm diode module holders, which are whatever was on amazon prime.
I left plenty of room between 1st and 2nd dichroics for correction optics and room between dichroic sets and scanners for beam expander/spatial filtering prior to the scanner block.
I accidentally killed the red diode last weekend, but have a new one incoming. Scanners are mostly tuned. I still cannot get the circle completely round, I am going to run through tuning again here tomorrow. Images are pretty solid though.
Blanking/color goes funny occasionally though on the ilda test pattern, I have no idea why. Its like timing get off between the scanners and drivers. Haven't had it happen on anything other than the ilda test pattern though. I can also see the blanking move while the pattern is displaying, not sure what to do about it.
So, ideas, questions, comments? Input is appreciated!
Casey