Results 1 to 3 of 3

Thread: DIY E-stop in trought ilda cable

  1. #1
    Join Date
    Mar 2017
    Posts
    50

    Default DIY E-stop in trought ilda cable

    I was thinking it is possible to make a e-stop box and put your ILDA cable trought abd cut the signals to the lasers, so i dont have to install anothkr cable than my ilda . ??

  2. #2
    Join Date
    Aug 2006
    Location
    Germany
    Posts
    111

    Default

    Normally breaking the ILDA Lines 4&17 should be enough. As to read in the ILDA Description this is the Interlock Line.
    A good Laser should stop working, cheap Chinese Crap is switching to DMX Mode an putting out his awful "Frames" ...

    But because i am from Germany i am not sure if this is OK for your FDA. Think not...
    Greetings
    Guido

    www.mylaserpage.de

  3. #3
    Join Date
    Mar 2017
    Posts
    50

    Default

    Im from canada im good for the fda my laser pass the customs without any certificate and i got a tarm two laser without dmx so i think i will be ok

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •