Results 1 to 9 of 9

Thread: NEOS 8 channel PCAOM with crystal and psu ready to go

  1. #1
    Join Date
    Aug 2009
    Posts
    8

    Laser Warning NEOS 8 channel PCAOM with crystal and psu ready to go

    https://www.ebay.com.au/itm/273405205069?ul_noapp=true
    Fully working ready to install

    low hours working

    full 8 channel with crystal ready to go once installed

    with some paperwork as well

    you just pay for shipping

    contact me for shipping

    was used with a American laser 68B air cooled so was only used at low power

    contact for more information

    this is a very nice unit and ready to go
    Also have a AL68B air and psu if you want it also just pay transport tube intact and running prior to storage

    INTERNATIONAL BUYERS WELCOME

  2. #2
    Join Date
    Jul 2009
    Location
    Orlando, FL
    Posts
    373

    Default

    Interested! Pm sent.

  3. #3
    Join Date
    Aug 2009
    Posts
    8

    Default

    Yes it is still available
    CHEERS

  4. #4
    Join Date
    Aug 2009
    Posts
    8

    Default

    Hi
    I would drop 50 of for being a photonlexicon member
    CHEERS

  5. #5
    Join Date
    Aug 2009
    Posts
    8

    Default pcaom use

    Quote Originally Posted by Lmx273 View Post
    Hi

    I would drop 50 of for being a photonlexicon member
    CHEERS
    Here is a video of the PCAOM being used with a AML Argon ion 68B laser
    using the dump beam from the PCAOM which goes to the second pair of scanners


    https://www.facebook.com/ray.hill.10888938/videos/153857042161215/



  6. #6
    Join Date
    Aug 2009
    Posts
    8

    Default

    Wish you all the best


    WARNING do not run the PCAOM without attaching to a very large heat-sink


    The PCAOM has a large heat sink that I constructed but it Does weigh a lot the fin part weights three pounds
    nine ounces and you still have another part of the heat sink attached to the PCAOM which I haven't weighted
    I just removed the fin part to weight it I will include the two pieces of the heat sink for free if you do not want to make your own just add some heat sink compound and bolt back together
    and you could make your own heat sink and save a bit on postage
    But if you do not mind paying the extra amount for transport I will include the heat sink as well
    with my heat sink the unit runs warm only. You do not want it running hot




    there is a good bit of paperwork with the unit as well
    the power supply has an Australian plug attached I will remove it
    to save any confusion
    the power supply is 90 to 250 volt ac so just add a USA plug to go


    the main beam went to a set of GS6800H scanners
    I then used the dump beam from the PCAOM with a few mirrors to aim into another set of scanners
    there fore two sets of scanners were being used all the time with very good results
    see the video
    https://www.facebook.com/ray.hill.10...3857042161215/


    I also had a 20mw helium neon laser mounted on top of the argon aiming to the rear of the laser with a couple of mirrors directing the red into the rear of the plasma tube this 68B has an open mirror mount at the rear of the tube I then adjusted the beam through the plasma tube to come out via the PCAOM I would turn down the argon till you could see the red . Strangely this worked extremely well
    but now days you could do the same with a one or two watts of red and just adjust the red channel on the PCAOM until the red line peaks out and bingo you have a white light argon diode hybrid
    hope that this helps
    CHEERS

  7. #7
    Join Date
    Aug 2009
    Posts
    8

    Default

    oops
    I meant CT6800H
    CHEERS

  8. #8
    Join Date
    Aug 2009
    Posts
    8

    Default

    Quote Originally Posted by Lmx273 View Post
    oops
    I meant CT6800H
    CHEERS
    Also the Argon ion American laser 68B air cooled and PCAOM in action

    https://www.youtube.com/channel/UCWi..._as=subscriber

  9. #9
    Join Date
    Aug 2009
    Posts
    8

    Default The PCAOM has been sold

    Quote Originally Posted by Lmx273 View Post
    Also the Argon ion American laser 68B air cooled and PCAOM in action

    https://www.youtube.com/channel/UCWi..._as=subscriber




    The PCAOM has been sold
    CHEERS

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •