Results 1 to 2 of 2

Thread: Laser color issue

  1. #1
    Join Date
    Apr 2014
    Location
    Auckland NZ
    Posts
    16

    Default Laser color issue

    Hello I've got 3 x 3 watt RGB animation lasers 30k. in the a few months ago one of the lasers when controlling and make them turn red one turns yellow. But only with idla control. Sound and auto and fine on all 3. I'm not sure where I need to start looking. I thought many a ldla issue but if I use one fb3 and put it as the first one the 2 lasers after are fine.
    Thanks Greg
    This is where i put all the lasers i have..and thats a lot..probably not enough space.

  2. #2
    Join Date
    Jan 2006
    Location
    Charleston, SC
    Posts
    2,147,489,446

    Default

    Sounds like a bent pin on the ILDA connector that is shorting the red + signal (pin 5) to the green + signal (pin 6). Running the projector in auto mode would bypass the ILDA port, so if the patterns look normal when in auto mode you can be certain that there aren't any problems with the green laser itself.

    I would take a close look at the ILDA-in connector on the back of the projector.

    Adam

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •