Results 1 to 1 of 1

Thread: Custom made Copper Chloride Laser

  1. #1
    Join Date
    Nov 2017
    Location
    Odessa, Ukraine
    Posts
    81

    Default Custom made Copper Chloride Laser

    Some time ago I visited my fellow glassblower and he made this laser tube for me from fused quartz. It has two side arms for placing copper halide in them an electrodes taken from linear flashlamps. I placed then the copper chloride that had unknown purity and quality. It had already changed colour to green, it indicated that CuCl partially turned in CuCl2. The active part of the tube with the side arms is surrounded by ceramic wool for thermal insulation. The active medium is 20 cm long and 12 mm wide. Anyway, I attached the vacuum pump and neon supply to the nipples of the tube set the neon flow at 10-15 Torr pressure and energised it with my "Lightsaber" CVL power unit. The copper chloride de-watered quickly and after warm up I saw unexpectidly bright superradiant lasing. The input power was around 1 kW with PRR 12 kHz. There was no special double-pulse timing, only continiously following pulses with high repetition rate. The optical cavity was absent. At these conditions the lasing power I would estimate about several hundreds of mW, like 100-200. The spot was too wide to be tightly focused, but I felt it quite hot on my skin.
    Attached Thumbnails Attached Thumbnails ??????????? 029.jpg  

    ??????????? 003.jpg  

    ??????????? 005.jpg  

    ??????????? 011.jpg  

    ??????????? 010.jpg  

    ??????????? 018.jpg  

    ??????????? 021.jpg  

    ??????????? 024.jpg  

    ??????????? 027.jpg  

    ??????????? 014.jpg  


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •