
Originally Posted by
laserist
laserist
There were 3 sets of 4 leverlite switches. The 4 on the left were beam kills. Up killed. Middle followed the tape, and down forced the beam on. The top 4 on the right were joystick overrides. Up killed the joystick signal, middle let the signal through, and down let the joystick signal through but killed the image signal. The 4 lower right selected between the hybrid (lower) card cage signal (All the stuff controlled by the data track) and the upper card cage. Up was the hybrid card cage stuff. Middle summed the two signals. Down was the upper card cage only. The 3 on the far right were originally motor enables (which was stupid) and were nothing on my machine in 2013. There were 2 more that involved color mod and chopper, that may have been left over from the digital recording system that Laser Images dropped a ton of money on and never made it into the field.
The upper card cage had the chopper, color mod, joystick, cycloid rotator, motor driver, and multiplier boards. Later the clipper and AO driver was added. The signals from the upper cage lower cage leverlite switches was summed at the cycloid rotator board and then to the multiplier board before the scan amps.
I understand the confusion about CYGN-A and B. Those signals were popular. In the upper cage the CYGN-B signals were summed together and sent through a master gain pot and summed to the CYGN-A master gain pot. The CYGN-B signal (before its master gain) went to the spiral switch. It also went to the fixed cycloid select switch with and without the danube rotation signal.
I should point out that the fixed rotation in the upper cage was out of phase relative to the lower cage - so when the leverlites were in the center (yellow) and the hybrid cage gain was ramped up with variable cycloids selected one image got smaller, one larger, and the other two would collapse to lines at 45 & -45 degrees.
Originally the projector wiring was pretty straight forward, and there was real training. Eventually the training was do it this way. When I was at the Smithsonian I set a goal to figure out everything I didn't know about the 6B. That's why I know where the signals from the switches go, or that there's a dual op-amp on the motor driver that - if blown - will kill the imagery, but the joystick signals will still get to the scanners.
As time went by there were mods. The clipper (with non-feedback scanners) wasn't my favorite effect, and was something that could be left on accidentally that resulted in depressing surge of blood pressure when discovered later in the show. They did something to variable image rotation where you could use the cycloid generators as rotation signals - another ticking time bomb. It got harder to learn how to run the early shows well, and easier to lean on cartoons and then came ADAT and that was all she wrote. Somebody may do a real show with the 6B that I refurbished in 2013, but Danny was doing ADAT shows in Van Nuys when I returned the projector, and never hooked it up. There's a whole bunch of reasons that people don't do live shows anymore, and one of them is, "It's hard..."
What phenomenal insight!!! I love this thread so much and so enthralled that Greg is making such progress in reconstructing a piece of the past and that laserist and Ron are no able to share their knowledgebase of the Laserium magic.
Many thanks guys.
________________________________
Everything depends on everything else