CYGN-B

[ronhip]

Thank you for the reply and suggestions, Alden.
Um, I believe that was a sketch from Cheech & Chong, with Cheech banging on Chong's door, pretending to be a policeman making a drug bust.
Chong- "Well if you're the police, then where's your badge?"
Cheech- 'Badge? I don't need no stinkin' badge, Bro."

Um... For those of us old enough to remember it, that was a paraphrase of a quote from the book and movie "The Treasure of the Sierra Madre". See:

https://en.wikipedia.org/wiki/Stinki...;%20badges.%22

But, this is off topic...

Ron

PS. I'm not technically old enough to "remember" this...

[lasermaster1977]

Um... For those of us old enough to remember it, that was a paraphrase of a quote from the book and movie "The Treasure of the Sierra Madre". See:

https://en.wikipedia.org/wiki/Stinki...;%20badges.%22

But, this is off topic...

Ron

PS. I'm not technically old enough to "remember" this...

You are 100% correct. Thanks for chiming in. Both of the newer references were satiric references to that movie classic.

[laserist]

You're only young once, but you can be immature forever.

Germaine Greer

[lasermaster1977]

You're only young once, but you can be immature forever.

Germaine Greer

I vote for what laserist said Germaine Greer said.


Roj, the CS42448 spec does indeed state that any of the 8 DAC differential output channels may be used single-ended. That could eliminate one TL084 and 8 10K 1% resistors. It may be worth considering at that.

Have you been sleeping?

[Greg]

The second build of the multabela ilda harness goes well enough. Seen in the photo is the portable juke configuration that provides four ilda outs plus audio. It seems a bit of a suitcase synthi vibe. Bringing up the section for inputs from generators and joysticks is next, so don't worry, there will be more wires.
Two mistakes in the PCB so far. First is miniscule footprints for the headers to the power rails. Second is the ilda ports mapped backward so those right angle db25 connectors that would have sat so nicely on the card edge are now flying in the air on wires.

[lasermaster1977]

The second build of the multabela ilda harness goes well enough. Seen in the photo is the portable juke configuration that provides four ilda outs plus audio. It seems a bit of a suitcase synthi vibe. Bringing up the section for inputs from generators and joysticks is next, so don't worry, there will be more wires.
Two mistakes in the PCB so far. First is miniscule footprints for the headers to the power rails. Second is the ilda ports mapped backward so those right angle db25 connectors that would have sat so nicely on the card edge are now flying in the air on wires.

...no matter what, the build you are working on now is always the Final Before Last, FBL for short. Keep on truckin'!

[Kevint]

Looks great Greg. Job well done.