Does anyone have the actual dimensions of the bottom of a maXYZ module? I'm making my own plates for the bottom so I can combine 2 of them and mount them to an optical breadboard.
Does anyone have the actual dimensions of the bottom of a maXYZ module? I'm making my own plates for the bottom so I can combine 2 of them and mount them to an optical breadboard.
CLICKY!!!
Admin: In the immortal words of Captain Planet: YOU HAVE THE POWER
Admin: (To quit being a bitch)
Anyone? Am I alone in wondering this?
CLICKY!!!
Admin: In the immortal words of Captain Planet: YOU HAVE THE POWER
Admin: (To quit being a bitch)
Just buy them. Everyone needs at least 2 of them....besides they never give trouble.
You are the only one that can make your dreams come true....and the only one that can stop them...A.M. Dietrich
HI,
I have just measured mine for you .. They are 77mm long by 46mm wide they are approx 30mm high. Caution the wire tail grommet is another 20mm long plus you may need to allow some more for the wires to bend around to wherever you want them.
These measurements are for one unit excluding any mount or heatsink.
Cheers
Ray
New Zealand
I have the modules, I need the measurements of the hole placement of the mounting plate.
CLICKY!!!
Admin: In the immortal words of Captain Planet: YOU HAVE THE POWER
Admin: (To quit being a bitch)
What you needed to know and what you actually asked for are two different things..
This is what you asked for..
Does anyone have the actual dimensions of the bottom of a maXYZ module?
I told you this in my reply.
However,did you bother to say thanks or please or would you mind looking at the base plate no !!
You know the nice things people usually do when asking questions of others.
People here are very helpful to each other how about a bit of courtesy it doesn't hurt.
Ray
NZ
Im not sure of the placement, however the threads are 6-32. Screws were hard to find over here in the metric world![]()
KVANT Australian projector sales
https://www.facebook.com/kvantaus/
Lasershowparts- Laser Parts at great prices
https://www.facebook.com/lasershowparts/
KVANT Australian projector sales
https://www.facebook.com/kvantaus/
Lasershowparts- Laser Parts at great prices
https://www.facebook.com/lasershowparts/
Yea, I thought of measuring mine, but it is firmly attached to a bi level breadboard that is inside my projector box. The screw holes are very hard to get to... dave's ruler idea is probably your fastest and best bet.Or you could PM marconi... He might know.
![]()
Love, peace, and grease,
allthat... aka: aaron@pangolin
CLICKY!!!
Admin: In the immortal words of Captain Planet: YOU HAVE THE POWER
Admin: (To quit being a bitch)