Hi All, does anyone have a setting up guide or 'how to adjust' a scanner system in a a Stealth Laser (It has Cambridge Galvos )
Its scanning fine but the size is very small only about 10-15 deg.
Thanks in advance
Hi All, does anyone have a setting up guide or 'how to adjust' a scanner system in a a Stealth Laser (It has Cambridge Galvos )
Its scanning fine but the size is very small only about 10-15 deg.
Thanks in advance
There is a pot that adjusts size but you will probably have to re-tune if you adjust too far.
There is a guide to tuning around here somewhere hopefully someone can provide the link. I have tuned many sets of galvos and its not an easy task but its not really that hard once you get the hang of it
Quis custodiet ipsos custodies?
Solid State Builders Group
Here's the scanner tuning tutorial I wrote years ago: http://lasershowparts.com/files/Arti...20Tutorial.pdf
One caveat: Make sure you are not scanning too wide before you start. 8 degrees is the spec, but you can tune at less than that if you want. If you are wider than 8 degrees you can still be OK, provided your scanners are capable. But if you try to tune and you are beyond your scanner's abilities, you will *never* get the pattern to look right. When in doubt, err on the side of a smaller scan angle when tuning.
Adam