Need Help: Universal Voltronics Laser Power Supply Wiring
Hi,
Does anyone have the wiring diagram for a Universal Voltronics BRC-50CT-35-HL2 Power Supply? This power supply is used to power a Laserscope Paragon Laser Tube.
I have a couple of huge Northwest CO2 lasers that are using a similar supply. These use the BRC-50-35 power supply.
The CO2 tubes are about 5" diameter and about 5 feet long, all housed in a nice 'compact' box.
I actually tried to find information on the web and found that Universal Voltronics was bought by Unipower. I then called Unipower and got connected to a very helpful Tech Support person. He called his contacts within the company and was not able to find a manual.
So I took a look at one of the power supplies from the huge CO2 lasers I have. They Universal Voltronics model LRC-50-40N-STD, not the BRC model but they look identical.
I attached a datasheet which has a wiring diagram. Only the first 5 pins (1-5) were used on the laser. Pins 1 and 4 were jumpered. Pin 3 is ground, leaving only pins 2 &5 for control.
I will take a better look and the other laser and make sure the connections are the same. I had removed the laser tube and power supply from the enclosure on one of them...
It states that Pin 5 is jumpered to common (Pin 3). Pin 4, HV Pulse Enable (+) is an input.
I connected Pin 5 to 3, Pin 4 to 1, applied 24VDC to the relay and I still do not get any high voltage output. I also have the high voltage terminals connected to a 40w CO2 laser tube.
Maybe this schematic for the LRC 50-40 might help. This is for a 240 VAC version; my power supply is actually a 120VAC version, but the schematic is still helpful. Thank you for providing the manual for these.
By the way, Said Nazemi at Parallax Technology in Waltham MA has a few power supplies available. They are not originals, but he had some made for him. He also mentioned that Power Clinic offers repairs on these supplies.