Results 1 to 2 of 2

Thread: Kvant Unity Laser issues.

  1. #1
    Join Date
    Aug 2017
    Posts
    4

    Default Kvant Unity Laser issues.

    I’m having issues with 2 kvant unity lasers. One seems to have the scanners suck intermittently, the hot beams will look like small sheets, lines will be squiggly, then five minutes later it will be back to normal. Then the other just quits when the FPS gets low and it makes a noise. It will also stop working until I go back to the scene that caused the problem and mess with the animation speed and scan speed until it works again. Once I get it working again I change the scene and everything works fine. Any help would be appreciated, I’m in Austin, Tx. Would be nice to have someone local help me out.

  2. #2
    Join Date
    Dec 2007
    Location
    The West
    Posts
    1,285

    Default

    1 of your issues seems like the scan guard activating.
    The other issue is a driver or scanner problem most likely.
    both of these issues can be resolved with some fine tuning, id send them back where you purchased them for repairs.
    You can also try adjusting the color delay settings within the software to see if that helps with the 2nd issue/ beams looking like they have wings...
    Last edited by carlos3621; 05-07-2021 at 19:57.
    RGB laser projectors
    Pangolin Beyond .NET
    APC40 Midi controllers
    Pangolin FB3 controllers
    DZ splitter
    LS MegaWatt Green Machine

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •