Doesn’t seem likely I will ever find them at power then, I’ve been looking at this crystal to make 607, but the mirrors are probably outrageous to buy: https://www.halide-crylink.com/fluor...r-ylf-crystal/
Doesn’t seem likely I will ever find them at power then, I’ve been looking at this crystal to make 607, but the mirrors are probably outrageous to buy: https://www.halide-crylink.com/fluor...r-ylf-crystal/
Glowing green eyes is a camera photoflash reflection.
Hello!
I have PR:Ylf crystals and optics for the resonators on stock!
BR
Phillip
PM sent, I've been looking at some of those crystals at 4Laser.com and their prices, curious what yours are.
Glowing green eyes is a camera photoflash reflection.
hi Phillip I was not referring to you for the record. I would also be interested. It was just way too expensive couple years back. Given the drive power in445, you should be able to get substantial output from this setup. 607 looks interesting but the 640 is what I was after thinking I’d get better beam from it than diodes. Not sure how it modulates however.
Be careful with opening these heads.. they dont take kind to any specs of dust with all that pump power!
The 577 head I have was opened by the seller who tried to get it working, he thought the pump diodes were bad and that they were 1154 nm. I will need to find a way to be sure dust doesn't cause a problem, I don't have a clean room, but I imagine there is a way to pump in inert gas to remove dust and seal it up again.
I am in process of buying some Pr:YLF crystals, but my Paypal address is the USA through US mail to an APO, AE address. I'd rather not ship through the mail and Phillip cannot ship to an address which is different from my PayPal address and be covered, so still working on this. If he listed them on ebay, they will allow me to ship to my address in Doha, Qatar and pay with PayPal, but not using Paypal directly.
Glowing green eyes is a camera photoflash reflection.
why buy pr:ylf when you arent sure its the problem? .. id first diagnose all the parts prior to it like the pump which gets the most wear next to the OPS chip.. aside from misalignments happening in the optical cavity due to dropping or whatever.
Heads do not have means to pump in inert gas.
Regarding clean room: Laminar flow hood or make a clean box.. better then nothing... dust is indeed an issue.
Also replace, add a dessicant pack in the head.. moisture isnt kind on that crystal and can cause it to degrade, turn white and into powder.
I'd need to fit an input and output attachment to pump the gas in and let the contaminated air out, but the Pr:YLF crystal isn't for this head, I want to make 607 nm orange.
I already have two 2 watt 577 nm lasers which are working, the cavity I'm writing about with the pump diode being weak is a third head of the same type. I need to further troubleshoot the weak head, although I am not so sure it is a weak diode as the seller thought, I've been wondering if it is really an alignment problem, or now whether the OPS needs replacement but with the hours an OPSL can run, perhaps that's not it. The optics in front of the laser diode are not glued to it that I can see, but butt up against it. Of course, they are designed for that specific diode array, I am aware that just putting in another diode of another design isn't going to match, I'd have to figure out how to make it work and this is not a short term project or an easy task, I might not be able to solve it, I'd bet I can't without the exact diode, but looking into it as a puzzle for the fun of it. Mostly, I want to learn about OPSL, doesn't matter so much I can get it working, just hobby fun.
Last edited by Laser57; 06-08-2022 at 13:31.
Glowing green eyes is a camera photoflash reflection.