I am working on a project for SELEM and have hit the limit of my Arduino knowledge.
I am wanting to trigger some WS2812B LED's to play a sequence in a loop using a radio controlled receiver and send a low signal to another pin to trigger a sound board.
So the radio controlled transmitter sends the signal to CH 3 to act as an enable. Ch 4 has a 3 position switch that I want to use to trigger 3 different LED effect. 2 of the 3 LED effects will have sound play when they are activated. This will require a low output signal on another 2 pins of the Arduino.
I already have the sequences I want to run and all of the hardware in place, I just don't have enough experience to finish the software.
This should be a walk in the park for an experienced programmer.
Here is a wiring diagram & flow chart of what I am trying to do.
Any help would be much appreciated!
Thank you,
Chris