do you have plans for the case and if so would you mind if I used them?
also, do you know anywhere I could get them sprayed or coated?
thanks,
Mike
do you have plans for the case and if so would you mind if I used them?
also, do you know anywhere I could get them sprayed or coated?
thanks,
Mike
Taking on the world one lasershow at a time
no plans no, but if i went down with you they know me and what they did, we could work something out very very easy. they are great guy and will do anything you ask.
and yes you could get it powder coated in great yeldham they said but not cheap £50-100
you just need to know the size you need. so you can fit everything in
Eat Sleep Lase Repeat
I've been thinking about the next step in this case thing, I'm assuming that the place isn't open at the weekend, so I'm wondering about seeing your case in the flesh and then being able to work out what (if anything) would need to change to fit my system, after that I'd then book a day off work to go and get the case specified and another to pick it up.
How would that be for you?
Mike
Taking on the world one lasershow at a time
I almost have finished my case.
Front:
Back:
Ilda in and ilda out DT40 Pro size controller, Key power switch and powerconnector
Top:
Top view. Wires is not connected...Will do it when I get time
Better view from above.
Again size: Length: 27cm Width : 31cm High : 10cm
Pangolin FB3 QS/LivePro/SMS2Laser
Riya MultiBus
Pangolin LD2000 Pro
Here's the case I've been putting together over the last few weeks that
measures 22" x 24". It's a combination of 3/4" particle board, 1/4" aluminum plate for the base and 12" x 24" x 1" breadboard on top of that for mounting the optics.
What would be the best way to get in touch with you to organise getting together?
Mike
Taking on the world one lasershow at a time
telephone, e-mail text??
Eat Sleep Lase Repeat
Crush : nice case! And I see you found a good place for my ex-green laser