DT40 pro trimmers labels?

[FabianM]

Hi, i have the DT40pro driver attached below from 2017. I need to tune it, but i can´t find a schematic for which trimmer function do ( gain , scale, HF ; LF..etc)
Does anybody have know?

DT40 Pro trimmers pot.jpeg

Thanks

[lasermaster1977]

Hi, i have the DT40pro driver attached below from 2017. I need to tune it, but i can´t find a schematic for which trimmer function do ( gain , scale, HF ; LF..etc)
Does anybody have know?

DT40 Pro trimmers pot.jpeg

Thanks

I would also be interested in FabianM's request since I have a very similar DT40 dual driver amp.

20230127_172028.jpg

On mine, I'm assuming the two center 10K pots that are oriented differently from the others and can be turned are for X & Y size adjustments.

EDIT: This helps answer the question. I did just find this JPG in my DT40 files which has labels on most of the trim pots.

DT30-40 Driver1.jpg

[FabianM]

Thank you lasermaster1977!! I remember tuning this controller up to 36k many years ago. Now, after 3 years without using them due to the pandemic, they became very unstable. I'm thinking maybe the problem may be the SD/DMX/Ilda board that is pre-driver. At the time I needed to replace one with a defective capacitor (low quality) when it was new...

I would also be interested in FabianM's request since I have a very similar DT40 dual driver amp.

20230127_172028.jpg

On mine, I'm assuming the two center 10K pots that are oriented differently from the others and can be turned are for X & Y size adjustments.

EDIT: This helps answer the question. I did just find this JPG in my DT40 files which has labels on most of the trim pots.

DT30-40 Driver1.jpg

[lasermaster1977]

Glad it helped!

It helped remind me that I bought my DT40Pro galvos and drivers back in 2017-18 (never been used as yet) and I need to finish the RGB projector I bought them for.