
Originally Posted by
Kevint
Quote: "Now I'm pretty sure that isn't what you are planning" - LOL! don't be too sure
I just measured the direct output voltage from a 4233 and it's 20V P-P. The power supply rails on the op amp are +/-15V. I was planning of summing 4ea of these signals together. So does that mean I would have a max of 80V? If that is the case what options are there?
Ok, 20V P-P centered around Ground, right? Since the instantaneous phase differences might be unpredictable, you always want to look at worst case, so 4 x 10 = 40V peak...ain't good.
If the train is too big to go through the tunnel, make the train smaller until it fits.
Can you reduce the signal gain of the 4233's so that 4 x nV peak <= 10V peak? Or each 4233 output voltage signal swing is + or - 2V peak.
Its kind of hard to say what the best solution is not knowing the purpose and configuration is of the 4233's.
Are these the MAX4233 op amps. Their working voltage range is 2.7v to 5.5v or +and- 1.35v up to +and- 2.75v, so how are you getting 20V P-P as an output??
Feel free to email me.
Last edited by lasermaster1977; 10-30-2024 at 22:45.
________________________________
Everything depends on everything else