Hi all, first time poster here, long time Madmapper user, and only just recently really getting deep in with Lasers. I've been getting some interesting drop outs with the Etherdream + Madmapper combo. Issues are not so much with the built in laser materials, but more when using a live texture and interpreting it. Basically it feels like the etherdream pipeline is getting bogged down and then disconnecting, like an emergency stop has been triggered. A few things can make this happen almost immediately, and other tweaks seem to do a good job of reducing the frequency. Easiest fix is to reduce the scan area, but it's just really annoying when it drops out because you have to pull the power out of the etherdream before it will reconnect... It seems the more complex and full on the pattern is, the higher the liklihood of it disconnecting....