PBS Cubes - 650nm and 473nm

[bridge]

Hi mechEng3
Used this cube,you also can test your lasers polarization rate, .
I test it with my blue lasers, It had high reflect or pass rate than yours.
Best regards!
Bridge

Sorry ... no pix right now. I have had the 2 Lasever 473nm units with the PBS cube and one mirror on a temp. mount. Preliminary results.........200 and 185mw input........= 351mw total output through all this. About 9% total losses due to optics and less than 2mw in both waste beams. I think I have it documented well enough to finally mount these guys. These specs may improve with proper tweaking and better alignment on the beam table. It was awesome to see that power of blue and no big thirsty gas tube in the room. Thanks Bridge for a job well done for my standpoint. Now I can see me having a little more than 1 watt RGB.

[Hemlock Mike]

MecEngr3 --

I got my cubes today in good condition. Now to do some reading about setup.

Thanks for your work.

Mike

[steve-o]

Mike,
Cube received; nice work, man.
Thanx.
Theyre purdy aint they?
Nice work Bridge
-Steve

[bridge]

Hi Steve
Thanks very much for your encourage.
Customer satisfaction is our always goal.
we will do our best to service our customer, the same all the time.
Best regards!
Bridge

Mike,
Cube received; nice work, man.
Thanx.
Theyre purdy aint they?
Nice work Bridge
-Steve

[laserbiker]

MecEngr3

Received mine yesterday. Looks beautiful! Thanks all involved.

Laserbiker

[MechEng3]

Marconi....You get the box yet??? Need to make sure all parcels are delivered. Thanks for putting up with me.

[marconi]

Yes, I did,, Thanks for the fast shipping.
I have not checked them thoroughly but did shoot some red thru
one of them breifly, seems to work..I'll know more later tonite.

[bridge]

Today ,got the pay from NL, will send it tomorrow.
how about spain? still need it?
Best regards!
Bridge

[Zoof]

great, looking forward to them!!

[andy_con]

cubes received, im not moaning just a comment.

one does have some damage on it