ive started building a 50mw 405nm module
http://www.laser-man.co.uk/2006/inde...d=52&Itemid=31
ive started building a 50mw 405nm module
http://www.laser-man.co.uk/2006/inde...d=52&Itemid=31
Eat Sleep Lase Repeat
Interesting. How did you break the bond of the adhesive holding the diode in place? I've stripped down a X16 DVD burner and got as far as the diode and a lump of heatsink it is going through. I'm a bit wary of going in with a screwdriver to seperate the two.
A lovely childhood. Just me my mother and the voices.
i have had 3 dvd burners now all of them 16x, two liteon and one emprex makes i purchased these because they were cheap and all three had a slightly different way of holding the diode in place the emprex soley relied on a good push fit into the mount but both the liteon's were a good push fit pluss they had some kind of themal epoxy resin around them to keep them in there place and help take the heat away all i done on all three is carefully cut right up to it with my dremill with a ultra thin cutting blade taking my time and once i have cut one side i just gently wedge the cut open with a thin sharp screw driver to crack the aluminium casting works a treat but you have to have nerves of steel if you working on a tight budjet hope this helps
Last edited by kaz; 09-22-2007 at 12:44. Reason: spelling mistake
i used a hacksaw the made on cut through the metal till i came to the diode. then used two pairs of plyers and pulled either way and the casing just broke in two
Eat Sleep Lase Repeat
How much was the blu-ray burner?
Love, peace, and grease,
allthat... aka: aaron@pangolin
£250 .
Eat Sleep Lase Repeat
well lets see if t works.
im currently getting 6mw!!!!!!!!!!!!
Eat Sleep Lase Repeat
Well, up to a pointer so far...
LOL sure is !
Eat Sleep Lase Repeat