I know how to make the angle smaller or bigger, but I don't understand how to get angle from the percent.
I know how to make the angle smaller or bigger, but I don't understand how to get angle from the percent.
CLICKY!!!
Admin: In the immortal words of Captain Planet: YOU HAVE THE POWER
Admin: (To quit being a bitch)
theres a thread somewhere about how to work out the angle
Eat Sleep Lase Repeat
http://www.pangolin.com/userhelp/scanangles.htm
this is on the pangolin website. If I remember correctly I think 13% would be about 8 degrees if your scanners are set for max 60 degrees full angle. Best way is to us the table on the Pangolin website as measure the distance and width.
Just a few quick comments about this.
First, Chinese scanners that I have analyzed so far do not do a very good job at bonding the coil. Wider scan angles = "more heat" dissipated by the coil. So in other words, wider = less life.
Second, the position sensor in Chinese scanners that I have analyzed so far is not very good. Wider scan angles = higher nonlinearity.
Third, flicker has nothing to do with scan angle. In most cases, it will be a "fact of life" with laser show...
Best regards,
William Benner