Maxyzmodules 225mW RED module, singles and duals
Decided a new thread was in order, Last one was not editable since the new site software upgrade
For Sale:
As seen on ebay and on this site !!!
Maxyzmodules RED 660nm 225mW laser module
As of : October 23 2007 (updated EUR)
for Photolexicon members ..
269.95USD or 189.97EUR each --
Shipping is 15USD for USA and Canada
25USd or 17.55EUR for International orders
284.95USD Total for USA or 294.95USD (207.52EUR) total for International
That's 539.90USD for a Pair ...(378.99EUR)
Same price shipping...Limited time offer ...
They come Analog modulation...Altho , You can use the analog units in TTL configuration. These will include the new driver board with full blanking to well
over 30khz. (useful to at least 100khz)
Also included FREE is a 9volt wallwart power supply (while supply lasts) they operate from 120/220ac 50/60hz
If you need a mounting plate, We offer them at 25USD 17.55EUR each, These are for mounting of a single unit.
If you need a dual mounting plate for combining a pair 45USD 31.59EUR each.
..set-up and predrilled for mounting of a MM-1 or equivalent mirror mount and a MM-1 /BS or equivalent like the one pictured in below.
We still have a few for you guys that want to roll your own:
Laser_line PBS cube 165.00USD or 115.81EUR
Laser-Line PBS cube mounted to MM1 or KMS is 235.00USD or 164.95EUR
Laser-Line mirror mounted to MM1 or KMS is 75.00USD or 52.65EUR
Plus shipping.
Grab a couple and find a Beamsplitter or Pol Cube and combine them for more power... Typical output is about 440mW out.
If you buy 2 , I will set one of them up opposite polarity for easier combining!!!
If you buy the whole set-up its 830USD plus 20USD in USA/Canada , 850USD total or 596.62EUR plus 21.06EUR international shipping , 617.68EUR total
Each unit is handcrafted. therefore.. great care is put in each unit before they leave..
The power is doublechecked with a Melles Griot and Scientech broadband power meters.
All parts are NEW .. except the heat sink which is black anodised However , We have just started to paint them with a special FLAT BLACK paint.
The beam diameter is less than 2.5mm (always) mostly around 2.2mm and divergence less than 1.0mR. Typically .8mR.
Only a few complete set-ups are available at a time.. so you may have to wait a day or two for us to build. We dont like having stuff laying around.
Oh and dont forget, if paying by PAYPAL please add the 4 percent they charge for their cut Thats about 34.00USD or 23.80EUR for the duals.
The combined plate has been redesigned slightly so no holes are covered and are spaced correctly.
Still using 3/8" holes spaced 5" each way on the 6" by 6" plates.
The diodes are NOT the small 100mW DVD diodes...!!!
And we thank everyone who has bought these...enjoy
Please PM me for more info
Thanks
Last edited by marconi; 10-23-2007 at 09:40.
"My signature has been taken, so Insert another here"
http://repairfaq.ece.drexel.edu/sam/laserfaq.htm
*^_^* aka PhiloUHF
Reply With Quote
Originally Posted by Laser Ben
