CNI 1 watt 532nm green
Lasever 500mw 635nm red
Lasever 200mw 473nm blue
Before I get the usually bashing for using the 10k galvos with crappy mirrors, please understand the beam on the red is huge, so huge it doesnt fit all the way on the mirrors even. I still get 20mw loss from the beam being too big. In good news, when I see adam this weekend I will get to replace my 10ks with 20ks from allthat.
Also, the configuration has alot to do with the red, instead of the typical green then red then blue I used green then blue then red. I needed the red as close the the galvos as possible
Special thanks to Mike for making the shims, these things work perfectly. My lasevers dont get hot at all. Fantastic. I also think this has alot to do with lasevers new design as well. I have been runing my laser for 2 days straight and power levels are still normal, well cept for the blue is now doing 210mw instead of 190mw.
Things to note. I replaced my two 5volt supplies from lasever with these. One of these runs both the red and the blue. Good at space saving plus lasevers got rather hot since they had no way to heatsink.
5V DC 10A 50W Regulated Switching Power Supply
http://cgi.ebay.com/ws/eBayISAPI.dll...m=230183445448
I also bought a triple mode power supply to run my fans, shutter and led
Triple Output Regulated Switching Power Supply
12vdc +/- at 1amp and 5vdc at 5amp
http://cgi.ebay.com/ws/eBayISAPI.dll...m=230184087083
I highly recommend those power supplies but the shipping from that seller took a week before it was even sent out.
Picture of shims