Hi all,
You have seen my 1.7 watt "green machine" before.. This is his brother "Greenie 2" ( 1.5 watt)
Coming in for production is their cousin Red GREEN and Blue..
The RGB is just in lofting mode right now nothing pinned down. Any comments always welcome.
I know the knob on the first Dichro is very close to the green however that is deliberate so you can out your fingers "around" the laser output tube and get easy access.
The base plate is heavy ali' with heavy support rails under for stiffeners. The plate is a 19" rack size so it goes into a roadcase.
Optics on top other junk under.
I guess I will have to use a foam filter to get air into the optic area as the two CNI lasers (500mw green and 250mw blue) have in built fans so a total seal would appear to be out of the question.
Interestingly nearly all of my lasers have in built fans except the Maxy.
I am waiting on three of the Pangolin Netbox OEM control cards to arrive.. These will be put in the laser cases so each unit is self contained and can run via Cat5 cable.
Oh and yes there will be safety shutters they are here, just not fitted yet.
Cheers
Ray
NZ