Autostart Adapter C315M

[Dominik Hangleiter]

Hi,

we just successfully killed the Autostart Adapter of our C315M Laser. There was some rubbish plastic screw to control the output power - it broke when we tried to use it .

Have any of you ever written a software to control that laser? Or do you have any clever ideas how else we can fix that problem?

Cheers,

Dom

[Jem]

Hi,

we just successfully killed the Autostart Adapter of our C315M Laser. There was some rubbish plastic screw to control the output power - it broke when we tried to use it .

Have any of you ever written a software to control that laser? Or do you have any clever ideas how else we can fix that problem?

Cheers,

Dom

Hi Dom

Software alone is only really any good if you have the digital controller (DC). Even then there's limited capability with the DC that barely makes it worthwhile writing a program, I simply use a terminal program to control mine. Commands such as 'On', 'Off' and 'SetPower' are probably the only ones you are likely to use.

There is a section on Sam's FAQ specifically relating to the C315m autostart adapter, if you look that up there are schematics available that may assist you to repair yours.

Cheers

Jem