Thanks for puting in the effort to do the drawing, I will prototype it at the weekend and let you know how I get on.
Regards rog8811
Thanks for puting in the effort to do the drawing, I will prototype it at the weekend and let you know how I get on.
Regards rog8811
I think, again, I am having earthing issues........ I quickly breadboarded an opto isolator driving an LED to test for blanking output, with popelscan running I had a dim but flashing LED. The moment I turned on the the power to the scanner the LED stayed resolutely brightly on, so not blankingI scoped the output from the DAC and sure enough the signal is there, at the outputs, with just the computer running and disappears as soon as the scanner is running.
I also looked at the blanking arrangement on the DX red/green driver (3 wires [red side of circuit/ground/green side of the circuit]) and discovered that to blank the LD's you need to short the red and/or green to ground to turn off the LD's. I cannot at the moment see how I need to configure the DAC blanking output to do that.
Any ideas on what to try with any of the above please?
Regards rog8811
Last edited by rog8811; 01-28-2008 at 01:32.