I`m now tired of my RGB scanner in my wooden box.
I`m now totally re-building my scanner from the beginning !
My old scanner had: Red lasers first, blue, then green..
This is what my NEW RGB scanner will have :
¤ total of 900mW analog White Laser DPSS
¤ DT-40 Scanners
¤ 16 Adjustable Bounce Beam mirrors
¤ Replace position of lasers (more blue output)
¤ 10mm Alu base plate
¤ ILDA in \ out connector
¤ Inside Case laser Temp LCD
Well that is what I know so far..
I dont post any pictures here on the forum (take to long time from Norway)
But I`m EVERYDAY update pictures from my Phone directly into my blog
So if you want to se my project getting finnish from start to end,
you can se my blog here: http://www.liteglow.vox.com/
(Day ONE at bottom, and the newest pictures on top...)
I consider to do something new....
To turn the galvo facing UP, to a mirror in 45`angle with adjustment...
Then I got the beam higher up (more easy to mount the bounce mirros)
and I got a change to adjust the beams 360degree all way around the box if I want..
And I can adjust it Up and down so you dont have to move the damn big laser case everytime you want to adjust it some small inces![]()
plz add some tips and ideas if you have any to share![]()
I`m not done cutting the base plate yet...
( I added a picture of the setup of the Mirrors and galvo, dont look at the lasers)
Thanx![]()