LASEVER 635nm 300mW

[andy_con]

ah didnt realise that was the red you had last time.

powder coated nice.

your av, have yopu posted that pic anywhere??? thats like perfect whie

[Insanity]

Same one, still going strong touch wood...

Here are some pics of the white for ya...

[Insanity]

By the way, you can see that the red is fatter and more divergent.. However, if you are doing only beams it looks ok and to get anything tighter means more power and more expense

[andy_con]

that is an amazing white, i hope mine will look that good when i get my green.

yeah i see the red, nothing major though

[Insanity]

We put 5v from a bench supply into each laser and this is how they measured up..

312mw Green
320mw Blue
350mw Red

Not scientifically corrent, but looks ok to me.. Even better with smoke in the room.. keeps me happy anyway

[andy_con]

nice set of powers there, makes my 100mw 473nm and 400mw 650nm look poo LOL

im just loving my RBP at the moment i hate to think what im gona be like when i get green and go full colour

[Insanity]

I saw your other thread, looks very nice to me, far from poo... But once you get the green in, you will never leave the house again

You have a Flashback with Live Pro right?

Here is a little tip for you that I stumbled upon by accident when playing one night.

Do a full colour cycle so you are displaying segments of different colour in a tunnel. You have 3 controls in the right hand panel, Scanrate, Brightness and colour. Try different settings on the colour fader, then you get colours like these which I thought were very different to the norm... Look at the second picture, brown laser light.... Now that is different, not the most appealing colour, but I certainly haven't seen brown light before...

Bet you can't wait to get the greenie in now

[andy_con]

yes i have seen that control.

i need ltosof fb3 help at the meet although i think there is a big problem with the FB3 but it might just be me?

[Insanity]

I'm no expert on the FB3 Hardware, but I know nearly every feature and control in Live Pro, so can give you tips on that one...

I have had a few issues with my FB3 Hardware, so have decided to go the whole hog and get a QM2000. Should be arriving tomorrow... Can't wait...

[andy_con]

ive got live pro

my question/problem

you set the projection zone (sizes) so you make the one for animations small so it does not over run the galvos.

but the speed is still on 100% so when dong beam shows and the size is at 100% and the scan rate is at 100% surely that is gona burn the galvos out, as its 30k at 8 degrees???

does that make any sense?